Carcass and Back Panel
The cabinet body should be square before the back panel is fixed. That panel often locks the case geometry in place. If it is attached while the sides are racked, drawers and doors may never align correctly even when the hardware is adjusted later.
Drawers and Slides
Left/right slides, stops and drawer fronts need consistent orientation. Test each drawer through its full travel before loading clothing. A drawer that binds should be corrected at the slide or case alignment rather than forced until the hardware wears in.
Wardrobe Doors and Hinges
Tall wardrobes may use multiple hinges per door, which makes reveal adjustments more sensitive. Set the cabinet level first, then adjust doors for even gaps. Mirrored or heavy doors may add handling requirements beyond a basic flat panel.
Shelves, Rods and Interior Storage
Confirm shelf positions, hanging-rod supports and any internal drawers before the doors make access more difficult. The planned clothing load matters when a wide shelf or rod spans a large opening.
Anti-Tip Restraints
Tall dressers and wardrobes commonly include anti-tip hardware. Attachment depends on the real wall substrate. For permanent built-in closet systems, use closet design and installation rather than treating the work as freestanding furniture assembly.
Final Placement
Because an assembled wardrobe can be too large for a bedroom doorway, move components to the final room first. Call NJ-GoodHome at (223) 226-1828 with the model, room photo and anchoring requirement.
Within a dresser & wardrobe assembly request, assembly & installation and ab machine assembly stay separate paths when either issue expands beyond this page’s scope.